Workshop Manuals Factory service & repair Rover
Rover 800 Workshop Manual (1996-1999)14 · Clutch
14 · Transmission

Master cylinder - KV6

Make
Rover
Model
800 Workshop Manual
Year
1996–1999
Section
Repairs › Master cylinder - KV6
ClutchMaster cylinder - KV6 · page 1 of 2

MASTER CYLINDER - KV6

Service repair no - 33.20.01

Remove

  1. Attach bleed tube to slave cylinder bleed screw, loosen screw and pump fluid from system. Tighten bleed screw.
Master cylinder - kv6 – Attach bleed tube to slave cylinder bleed screw, loosen screw and pump fluid from system.
  1. Position cloth to catch fluid spillage.

CAUTION: Do not allow brake fluid to contact paint finished surfaces as paint may be damaged. If spilled, remove fluid and clean area with clean warm water.

  1. Release clip and disconnect feed hose from master cylinder.
  2. Disconnect pipe union from damper.
  3. Release pipe from body clip, position pipe aside.

CAUTION: Plug the connections.

  1. Release 4 turnbuckles and remove closing panel from below steering column.
Master cylinder - kv6 – Release 4 turnbuckles and remove closing panel from below steering column.
  1. Withdraw ’R’ clip and remove clevis pin from push rod fork and clutch pedal.
  2. Remove 2 nuts securing master cylinder.

Parts & tools for this job For 1996 Rover 800

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.