Pump - power steering - diesel (page 2 of 3)

Refit

1. Clean PAS pump and adaptor pipe. Steering column assembly and lock
2. Fit new 'O' ring to adaptor pipe, fit pipe and tighten bolts to 10 Nm (7 lbf.ft).

$% 57.40.01

3. Position mounting bracket to PAS pump, fit but do not tighten bolt.

Remove

4. Position PAS pump and align pump drive to coolant pump. Fit and tighten bolts to 25 Nm (18 lbf.ft).
5. Tighten mounting plate bolt to 25 Nm (18 lbf.ft).
6. Clean PAS pump and pipe union.
7. Fit and tighten PAS pump pressure pipe to 20 Nm (15 lbf.ft).
8. Fit PAS pump inlet hose and secure with clip.
9. Clean PAS pump and pulley mating faces.
10. Position PAS pump pulley, fit and tighten bolts to 10 Nm (7 lbf.ft).
11. Fit auxiliary drive belt. CHARGING AND STARTING, REPAIRS, Belt - auxiliary drive.
12. Bleed power steering system. STEERING, ADJUSTMENTS, Hydraulic system - bleed.
1. Remove steering column intermediate shaft. STEERING, REPAIRS, Shaft - intermediate and universal joint - steering column.
2. Remove rotary coupler. RESTRAINT SYSTEMS, REPAIRS, Rotary coupler.
3. Open fascia lower access panel.
4. Remove steering column nacelle. STEERING, REPAIRS, Nacelle - steering column.

5. Disconnect multiplug and illumination bulb from passive coil and remove passive coil.