Camshaft timing belt - air con - VVC engines

17. Ensuring that pointer maintains correct position, tighten tensioner bolt to 25 Nm.
18. Using crankshaft pulley bolt, rotate crankshaft 2 turns clockwise and align camshaft gear timing marks.
19. Check that pointer is still correctly aligned with index wire.
20. Fit camshaft timing belt upper front cover. See this section.
21. Remove stand(s) and lower vehicle.
22. Connect battery earth lead.

CAMSHAFT TIMING BELT - AIR CON - VVC ENGINES

Service repair no - 12.65.18/20

Remove

CAUTION: Timing belts must be replaced if cylinder head is to be removed or new timing gears, tensioner or coolant pump are to be fitted. Timing belts must be stored and handled with care. Always store a timing belt on its edge with a bend radius greater than 50 mm. Do not use a timing belt that has been twisted or bent double as this can damage the reinforcing fibres. Do not use a timing belt if debris other than belt dust is found in timing cover. Do not use a timing belt if partial engine seizure has occurred. Do not use a timing belt if belt mileage exceeds 48,000 (77,000 km). Do not use an oil or coolant contaminated timing belt.

NOTE: The cause of contamination MUST be rectified.

1. Disconnect battery earth lead.
2. Raise front of vehicle.

WARNING: Support on safety stands.

3. Remove timing belt upper front cover. See this section.