Crankshaft pulley - manual gearbox
- Make
- MG
- Model
- MGF Factory Workshop Manual
- Year
- 1995–2000
- Section
- Repairs › Crankshaft pulley - manual gearbox
‹ Prev Camshaft rear oil seal - inlet - MPi MEMS 3 (2000my on); VVC MEMS 3 (2001my on)Next › Crankshaft pulley - sequential auto (EM-CVT)
EngineCrankshaft pulley - manual gearbox
- Ensure area around camshaft oil seal is clean and free from oil.
- Position cover plate, fit bolts and tighten to 10 Nm.
- Secure CMP harness to cover plate and connect CMP multiplug.
- Fit engine cover. See this section.
- Connect battery earth lead.
CRANKSHAFT PULLEY - MANUAL GEARBOX
Service repair no - 12.21.01
Remove
- Disconnect battery earth lead.
- Raise rear of vehicle.
WARNING: Support on safety stands.
- Remove road wheel(s).
- Remove alternator drive belt. See ELECTRICAL, Repairs.
- Remove starter motor. See ELECTRICAL, Repairs.
- Lock crankshaft using tool 18G 1742.
‹ Prev Camshaft rear oil seal - inlet - MPi MEMS 3 (2000my on); VVC MEMS 3 (2001my on)Next › Crankshaft pulley - sequential auto (EM-CVT)
Parts & tools for this job For 1995 MG MGF
- PARTEngine gasket setSearch: MG MGF 1995 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.