Camshaft rear oil seal (page 4 of 5)
- Make
- Rover
- Model
- 400 Workshop Manual
- Year
- 1995–2000
- Section
- Repairs
Engine - L SeriesCamshaft rear oil seal · page 4 of 5
- Using a torque wrench fitted to tensioner pulley backplate, apply a clockwise, as viewed from rear of engine, torque loading of 6 Nm to drive belt. Maintain loading and tighten tensioner pulley Allen bolt to 44 Nm.
CAUTION: Do not exceed specified torque figure.
- Remove FIP gear locking pin 18G 1717 and timing pin 18G 1523.
- Rotate crankshaft clockwise 2 complete revolutions and fit timing pin 18G 1523.
CAUTION: Ensure pin is fully inserted into hole in flywheel.
- Check that camshaft drive gear timing mark is aligned with mark on rear cover.
Parts & tools for this job For 1995 Rover 400
- PARTEngine gasket setSearch: Rover 400 1995 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.