12 · Steering & suspension

Note: (page 6 of 6)

SteeringNote: · page 6 of 6

A	Cylinder End Seal – replace	X	Cylinder Housing
B	Bushing Stopper Ring	Y	Steering Rack
C	Snap Ring	Z	Transfer Hose Band
D	Gear Housing Cap	AA	Cylinder
E	Steering Pinion Seal – replace	BB	Cylinder Bolt
F	O-ring – replace	CC	Transfer Hose Clip
G	6 mm Flange Bolt	DD	Stop Washer
H	Rack Bushing B	EE	Lock Washer
I	Retaining Washer	FF	Back-up Ring
J	Ball Bearing	GG	Cylinder End Seal – replace
K	Snap Ring	HH	Boot Band
L	Back-up Ring	II	Rack End
M	Seal Retainer	JJ	Piston Seal Ring – replace
N	Cylinder Cap	KK	Cotter Pin – replace
O	Rack Guide Screw	LL	Air Transfer Hose
P	Port Orifices	MM	Boot – replace
Q	Spring	NN	Tie-rod End Locknut
R	Rack Guide	OO	Boot
S	Gear Housing	PP	Tie-rod End
T	Rack Bushing A	QQ	Locknut
U	Cylinder Spring	RR	Pinion
V	Piston (part of rack)	SS	Ball Bearing
W	Rubber Band

Note:

Clean the disassembled parts with a solvent and dry them with compressed air. Do not dip the rubber parts in a solvent.
Always replace the O-rings and rubber seals with new ones before assembly.
Apply recommended power steering fluid or steering grease to the parts indicated in the assembly procedures.
Do not allow dust, dirt or other foreign materials to enter the power steering system.
Use the appropriate special tools to install them where necessary.

Parts & tools for this job For Rover 600

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.