Door - tail (page 2 of 2)

19. Remove 6 bolts securing tail door hinges to body and, with assistance, remove tail door. Glass - front or rear door

Refit

$% 76.31.01

1. Support the tail door on a jack, using a block of wood to protect the door.

Remove

2. With assistance position door. Fit securing bolts but do not tighten at this stage.
3. Fit washer and spring clip securing check strap to aperture.
4. Adjust position of tail door in relation to aperture, ensuring gaps around all 4 edges are consistent, and door closes cleanly onto dove tail.
5. When tail door is correctly adjusted, tighten tail door hinge bolts to 34 Nm (25 lbf.ft).
6. Feed harness and washer tube through outer edge of door and connect harness sleeve to door.
7. Secure harness to tail door with clips.
8. Connect washer tube to rear of wiper arm.
9. Remove tape from draw string and secure to CHMSL wires.
10. Draw wires through tail door and connect Lucars to CHMSL.
11. Fit CHMSL cover and secure with screws.
12. Connect multiplug of number plate lamp.
13. Connect Lucars to HRW.
14. Connect multiplug to rear wiper motor.
15. Connect multiplug to door latch.
16. Fit water shedder to door.
17. Fit tail door trim casing. DOORS, REPAIRS, Trim casing - tail door.
18. Fit spare wheel to tail door.
10. Slide out and remove glass from frame.
1. Remove door trim casing. DOORS, REPAIRS, Trim casing - front door. DOORS, REPAIRS, Trim casing - rear door.
2. Carefully release water shedder from door.
3. Front door glass only: Remove exterior door mirror. EXTERIOR FITTINGS, REPAIRS, Mirror - exterior - electric.
4. Remove inner waist seal.

Front door shown, rear door similar

5. Remove 2 clips securing ends of outer waist seal.
6. Remove outer waist seal.
7. Remove 2 bolts securing glass to regulator. If necessary, lower glass to access bolts.
8. Remove bolts securing frame to door.
9. Remove door frame complete with glass.