Range Rover P38
ELECTRICAL
7
REPAIR
DRIVE BELT TENSIONER - V8
Service repair no - 86.10.06
Remove
1. Disconnect battery negative lead.
2. Remove radiator cooling fan cowl.
3. Remove alternator drive belt.
See this section.
4. Remove tensioner pulley securing bolt. Remove
pulley.
5. Remove tensioner securing bolt. Remove
tensioner.
Refit
6. Ensure mating faces are clean.
7. Fit tensioner.
CAUTION: Ensure tensioner dowel is
correctly located.
8. Fit tensioner securing bolt. Tighten to
39 Nm.
(29 lbf.ft)
9. Fit tensioner pulley. Secure with bolt. Tighten to
50 Nm. (37 lbf.ft)
CAUTION: Fit special washer with raised
face towards pulley.
10. Fit alternator drive belt.
See this section.
11. Fit radiator cooling fan cowl.
12. Reconnect battery negative lead.