Workshop Manuals Factory service & repair Rover
01 Introduction02 General information03 Information04 Engine - KV605 Engine - diesel06 Engine - T Series07 Emission control08 Engine management system - MEMS09 Engine management system - EDC10 Fuel delivery system11 Cooling system - KV612 Cooling system - diesel13 Manifold & exhaust systems14 Clutch15 Manual gearbox - PG116 Manual gearbox - T75017 Automatic gearbox - JF403E18 Drive shafts19 Steering20 Brakes21 Restraint systems22 Body23 Air conditioning24 Wipers & washers25 Electrical26 Instruments
Rover 800 Workshop Manual (1996-1999)21 · Restraint systems
21 · Body & interior

Overnight storage

Make
Rover
Model
800 Workshop Manual
Year
1996–1999
Section
Precautions › Overnight storage
Restraint systemsOvernight storage

Overnight storage

Airbag modules are classed as explosive articles and as such must be stored in an approved secure steel cabinet which has been registered by the local authority.

FRONT SEAT BELT PRE-TENSIONER STORAGE

For temporary storage of the front seat belt pre-tensioner during service, observe the following precautions:

  • Place the pre-tensioner in designated storage area.
  • If no designated storage area is available, the pre-tensioner may be stored in the boot of the vehicle from which it has been removed. Always lock the boot when the pre-tensioner is stored in it and inform the workshop supervisor.
  • Store the removed pre-tensioner on a secure flat surface away from heat, oil, grease, detergent or water.

CAUTION: Improper handling or storage can damage the pre-tensioner assembly. If damage is suspected, install a new assembly.

Overnight storage

Front seat belt pre-tensioners are classed as explosive articles and as such must be stored in an approved secure steel cabinet which has been registered by the local authority.

Parts & tools for this job For 1996 Rover 800

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.