Passenger airbag module

Refit

1. Position pre-tensioner and reel assembly, align seat belt reel, fit and tighten Torx screw to 32 Nm and M6 bolt to 9 Nm.

CAUTION: Seat belt reel and anchorage bolts are ’Duo Taptite’ self-tapping bolts. They may be reused but it is essential that they are not allowed to become cross-threaded.

2. Position seat belt retaining bar, fit bolts and tighten to 32 Nm.
3. Fit bolt covers.
4. Align seat belt anchorage to B/C post, tighten bolt to 32 Nm and fit bolt cover.
5. Locate pre-tensioner tube to studs, fit multiplug bracket to top stud, fit nuts and tighten to 6 Nm.
6. Connect pre-tensioner multiplug and secure to bracket.
7. Position pre-tensioner cable to body harness, ensuring cable run is outboard of harness.
8. Secure cable to harness with cable ties.
9. Fit rear quarter lower trim casing. See BODY, Repairs.
10. Check SRS system using TestBook.

PASSENGER AIRBAG MODULE

Service repair no - 76.73.69

CAUTION: Replace the airbag every 10 years.

• Do not install used SRS parts from

• another car. When repairing an SRS system always use genuine new Rover parts. • Carefully inspect the airbag assembly before installing. Do not install an airbag assembly that show signs of being dropped or improperly handled, such as dents, cracks or deformation. • Do not try to disassemble or tamper with the airbag assembly. • Special bolts are necessary for installing the air assembly. Do not use other bolts.

Remove

1. Remove key from starter switch.

CAUTION: Wait 10 minutes to allow SRS back-up power circuit to discharge before commencing work.

2. Disconnect both battery leads, earth lead first.