Radiator.

Refit 27. Position A/C compressor, fit bolts and tighten

1. Clean mating faces of engine and gearbox, dowel and dowel holes. 28. Connect multiplug to A/C compressor.
2. Lubricate splines and bearing surface on first 29. Clean ACE pump and housing mating faces, motion shaft with grease.
3. With assistance position engine in engine bay, 30. Position ACE pump, fit bolts and tighten to 22 align to gearbox and locate on dowels.
4. Position support brackets, fit bell housing bolts 31. Clean all pulley 'V's, fit auxiliary drive belt, and tighten to 50 Nm (37 lbf.ft).
5. Position engine mountings, fit nuts and tighten to 85 Nm (63 lbf.ft). 32. Ensure auxiliary drive belt is correctly located
6. Lower lifting equipment and remove from engine. 33. Fit radiator.
7. Models with automatic gearbox: Align torque converter to drive plate, fit bolts and tighten to 50 Nm (37 lbf.ft). Fit access plug. 34. Fit top hose and secure with clips.
8. Fit exhaust front pipe. 35. Connect fuel pipe to fuel rail. MANIFOLDS AND EXHAUST 36. Position ignition coils and connect ht leads. SYSTEMS - V8, REPAIRS, Front pipe. 37. Fit upper inlet manifold.
9. Position oil cooling pipe saddle clamps and tighten bolts.
10. Position engine harness into foot well.
11. Connect 5 multiplugs to ECM.
12. Fit toe board and secure with trim fixings. 38. Fit new oil filter and refill engine with oil.
13. Connect engine harness earth to body and secure with nut.
14. Connect engine harness to main harness multiplug. 39. Top up gearbox oil.
15. Connect multiplug to EVAP purge valve.
16. Connect engine harness multiplugs to fuse box.
17. Connect starter lead to fuse box and secure with nut.
18. Connect engine harness positive lead to battery and tighten nut.
19. Fit fuse box cover.
20. Position engine earth lead and secure with bolt.
21. Position coolant rail and secure with bolt.
22. Connect harness clips to coolant rail.
23. Connect hose to coolant rail and coolant pump and secure with clips.
24. Connect PAS pump high and low pressure pipes and secure with clips.
25. Position oil cooling pipe saddle clamp to PAS pump housing and secure with bolt.
26. Clean A/C compressor and housing mating faces, dowels and dowel holes.

to 22 Nm (16 lbf.ft).

dowels and dowel holes.

Nm (16 lbf.ft).

using a 15mm spanner, release belt tensioner secure belt and re-tension drive belt .

on all pulleys.

COOLING SYSTEM - V8, REPAIRS,

Radiator.

MANIFOLDS AND EXHAUST SYSTEMS - V8, REPAIRS, Gasket - inlet manifold - upper - Without Secondary Air

Injection.

ENGINE - V8, REPAIRS, Filter - oil. MAINTENANCE, PROCEDURES, Engine oil - V8 engine.

MAINTENANCE, PROCEDURES, Automatic gearbox.