Range Rover P38
ELECTRICAL
19
REPAIR
Disassemble
11. Remove 2 screws securing trim moulding to
headlamp housing. Remove trim.
12. Remove rubber boot from headlamp wiper motor
retaining nut shaft.
13. Remove nut securing headlamp wiper motor.
Remove motor.
Assemble
14. Fit headlamp wiper motor. Secure with nut.
15. Fit rubber boot to headlamp wiper motor
retaining nut shaft.
16. Fit trim moulding to headlamp assembly. Secure
with screws.
Refit
17. Position headlamp housing assembly.
18. Connect headlamp and wiper motor multiplugs.
19. Secure housing to front panel with screws.
20. Secure housing to bonnet platform with bolt.
21. Secure housing to inner wing platform with bolt.
22. Position wiper arm to drive spindle. Connect
wash wipe tube.
23. Secure wiper arm with nut, tighten to
10 Nm
(7 lbf.ft).
24. Secure headlamp wiper arm retaining nut cover.
25. Refit front grille.
See CHASSIS AND BODY,
Repair.
26. Refit indicator.
See this section.