Engine Coolant Fan Replacement - 1.4L LDD (Engine Cooling)
- Make
- Vauxhall
- Model
- Astra J
- Section
- Engine Cooling › Repair Instructions › Engine Coolant Fan Replacement - 1.4L LDD
‹ Prev Engine Coolant Fan Replacement - LDE,LLU,LUJ,LUW,LXV, LXT,L2W,2H0-ATNext › Engine Coolant Fan Replacement - 1.6L LDE, LLU, and MT
EngineEngine Coolant Fan Replacement - 1.4L LDD
Engine Coolant Fan Replacement (1.4L LDD)Removal Procedure
|
| 1. | Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection |
| 2. | Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle |
| 3. | Drain the cooling system. Refer to Cooling System Draining and Filling |
| 4. | Remove the radiator inlet hose. Refer to Radiator Inlet Hose Replacement |
| 5. | Disconnect the engine coolant fan resistor wiring harness plug (1). |
| 6. | Unclip all retainer clips and remove the wiring harness (3). |
Note: You stand against driving direction. |
| 7. | Unclip the engine coolant fan shroud (1) at the shown four mounting points. |
| 8. | Remove the engine coolant fan shroud (1). |
| 9. | Remove the engine coolant fan resistor (1) by uncliping the retainer clip (2). |
| 10. | Unclip the engine coolant fan to engine coolant fan resistor wiring harness (arrows). |
| 11. | Remove the 3 engine coolant fan engine bolts (3) from the engine coolant fan. |
| 12. | Remove the engine coolant fan. |
Installation Procedure
| 1. | Install the engine coolant fan. |
Caution: Refer to Fastener Caution |
| 2. | Install the 3 engine coolant fan engine bolts (3) to the engine coolant fan and tighten. |
| 3. | Clip in the engine coolant fan to the engine coolant fan resistor wiring harness (arrows). |
| 4. | Install the engine coolant fan resistor (1) by clipping the retainer clip (2). |
| 5. | Install the engine coolant fan shroud (1). |
| 6. | Clip in the engine coolant fan shroud (1) at the shown four mounting points. |
| 7. | Connect the engine coolant fan resistor wiring harness plug (1). |
| 8. | Install the wiring harness (3) and clip in all retainer clips. |
| 9. | Install the ground cable and the ground cable nut and tighten to 10 N·m (89 lb in) . |
| 10. | Install the radiator inlet hose. Refer to Radiator Inlet Hose Replacement |
| 11. | Install the radiator outlet hose. Refer to Radiator Outlet Hose Replacement |
| 12. | Top up the cooling system. Refer to Cooling System Draining and Filling |
| 13. | Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection |
‹ Prev Engine Coolant Fan Replacement - LDE,LLU,LUJ,LUW,LXV, LXT,L2W,2H0-ATNext › Engine Coolant Fan Replacement - 1.6L LDE, LLU, and MT
Parts & tools for this job For Vauxhall Astra
- PARTEngine gasket setSearch: Vauxhall Astra engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.