General failure warning light not working
- Make
- Fiat
- Model
- 500 Factory Service Manual
- Year
- 2007–2024
- Section
- Instrument panel › General failure warning light not working
‹ Prev Seat belt not fastened warning light not workingNext › General failure warning light on constantly
Fault diagnosisGeneral failure warning light not working
GENERAL FAILURE WARNING LIGHT NOT WORKING
Even if one of the functions signalled by the general failure warning light is faulty, the warning light in the instrument panel does not come on
N.B: The following functions cause the activation of the general failure warning light:
- Inertia switch (FIS) operation
- Fuel cut off activated
- Fuel cut off not available
- Parking sensor failure (if fitted)
- Robotized gearbox safety signals
- Engine oil pressure sensor failure
- Exterior lighting failure
| Test results | ||||
| 1 | CAN CHECK | All OK | Problems encountered | Operation |
|---|---|---|---|---|
Connect an EXAMINER and check the following on CAN NETWORK INFORMATION:
| Move on to Step 2 | Fault on CAN network | Continue as instructed by the diagnostic equipment | |
| 2 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
| Connect the diagnostic equipment and check the operation of the general failure warning light in active diagnosis at the INSTRUMENT PANEL NODE | End of diagnosis | The warning light does not flash | Replace the Instrument Panel | |
‹ Prev Seat belt not fastened warning light not workingNext › General failure warning light on constantly
Parts & tools for this job For 2007 Fiat 500
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Fiat 500
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.