Mil warning light stays on (engine starts)

Fault diagnosisMil warning light stays on (engine starts)

MIL WARNING LIGHT STAYS ON (ENGINE STARTS)

1.2 8v, 1.3 Multijet, 1.4 16v

The M.I.L. warning light remains on when the engine is running.

1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
		Test results
	Connect the Examiner diagnostic equipment to the diagnostic connector and check that there are no system errors at the Engine Management Node	Move on to Step 2	Presence of errors in the system	Proceed as instructed by the diagnostic equipment
2	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Keeping the diagnostic equipment connected to the diagnostic socket, check the operation of the M.I.L. warning light at the control panel, by using active diagnosis	Move on to Step 3	The warning light does not flash	Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R
3	CORRECT OPERATION CHECK	All OK	Problems encountered	Operation
	Check that the engine control unit is working properly	End of diagnosis.	Engine control unit defective	Replace the engine management control unit Op. 1056B82 INJECTION/IGNITION SYSTEM E.C.U. (ONE) - R + R
3	CORRECT OPERATION CHECK	All OK	Problems encountered	Operation
	Check that the engine control unit is working properly	End of diagnosis.	Engine control unit defective	Replace the engine management control unit Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.