22 · Diagnostics

Recharging warning light on

Fault diagnosisRecharging warning light on

RECHARGING WARNING LIGHT ON

1.2 8v, 1.3 Multijet, 1.4 16v

After the engine has been started, the recharging warning light in the Instrument Panel Node remains on.

1	ALTERNATOR CHECK	All OK	Problems encountered	Operation
		Test results
	Check carrying out See Test 5530AB Check alternator operation that the alternator operates correctly	End of diagnosis	Alternator operating faults	Move on to Step 2
2	ELECTRICAL CIRCUIT CHECK	All OK	Problems encountered	Operation
	Check the continuity and insulation of the electrical circuit between the battery, starter motor and alternator See E5010 STARTING AND RECHARING	Move on to Step 3	1. Connections faulty 2. Alternator defective	1. Restore the correct connections 2. Replace the alternator. Op. 5530A10
3	ACTIVE DIAGNOSIS CHECK	All OK	Problems encountered	Operation
	With the Examiner in Instrument Panel Node mode, check that the generator warning light is correctly activated in Active Diagnosis.	Move on to Step 4	The alternator warning light is not activated	Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R
4	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Using an Examiner check, in Body Computer Node mode, that there are no errors.	Move on to Step 5	Presence of errors	Continue following the instructions on the diagnostic instrument
5	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Check that the Body Computer Node is working properly	End of diagnosis	Body Computer defective	Replace Body Computer Op. 5505A32 BODY COMPUTER - R.R

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.