Workshop Manuals Factory service & repair Land Rover
01 Introduction02 General specification data03 Engine tuning data04 General fitting reminders05 Lubricants, fluids and capacities06 Maintenance07 Engine08 Emission control09 Fuel system10 Cooling system11 Manifold and exhaust system12 Transfer gearbox13 Automatic gearbox14 Propeller shafts15 Rear axle and final drive16 Front axle and final drive17 Steering18 Front suspension19 Rear suspension20 Brakes21 Wheels and tyres22 Chassis and body23 Heating and ventilation24 Air conditioning25 Wipers and washers26 Electrical27 Instruments
Land Rover Defender 90 Workshop Manual (NAS)22 · Chassis and body
22 · Body & interior

Door glass - front door

Make
Land Rover
Model
Defender 90 Workshop Manual (NAS)
Section
Repair › Door glass - front door
Chassis and bodyDoor glass - front door

DOOR GLASS - FRONT DOOR

Door glass - front door

Service repair no - 76.31.01

Remove

  1. Taking care not to damage paint, prise exterior waist weather strip from door.
  2. Remove timber support and lower glass to bottom of door.
  3. Remove mounting panel. See Mounting panel - front door
  4. Remove window regulator. See Window regulator - front door
  5. Push glass up to top of its travel and support with a suitable length of timber.
  6. Remove 2 self tapping screws securing window glass runner on latch side of door and single screw from hinge side.
  7. Ease runner from glass at hinge side of door, lift glass over bottom edge of door and withdraw.

Parts & tools for this job For Land Rover Defender

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.