Workshop Manuals Factory service & repair Land Rover
Land Rover Discovery II (UK)10 · Engine - V8
10 · Engine

Strainer - oil pick-up (page 4 of 4)

Make
Land Rover
Model
Discovery II (UK)
Section
Repairs
Engine - V8Strainer - oil pick-up · page 4 of 4
  1. Clean gearbox oil cooler pipe 'O' ring recess and mating face. Switch - oil pressure
  2. Lubricate and fit new 'O' ring to gearbox oil cooler pipe.

$% 12.60.50

  1. Position pipe and tighten nut.
  2. Lower front of vehicle.

Remove

  1. Position cross member to chassis, fit bolts and tighten to 25 Nm (18 lbf.ft).
  2. Refill engine oil and fit dipstick.
  3. Connect battery earth lead.
  4. Fit battery cover and retain with fixings.

Refit

  1. Release fixings and remove battery cover.
  2. Disconnect battery earth lead.
  3. Raise front of vehicle.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

  1. Remove fixings and remove underbelly panel.
Remove fixings and remove underbelly panel.
  1. Disconnect multiplug from oil pressure switch.
  2. Position container below switch to catch oil spillage.
  3. Remove oil pressure switch and discard sealing washer.
  4. Clean oil pressure switch threads.
  5. Fit new sealing washer to switch.
  6. Fit oil pressure switch and tighten to 15 Nm (11 lbf.ft) .
  7. Connect multiplug to oil pressure switch.
  8. Fit underbelly panel and secure with fixings.
  9. Remove stand(s) and lower vehicle.
  10. Connect battery earth lead.
  11. Fit battery cover and retain with fixings.
  12. Top up engine oil.

Parts & tools for this job For Land Rover Discovery

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.