Front valance assembly - LH (page 2 of 2)

Refit

1. Fit windscreen side finisher. 'A' post assembly EXTERIOR FITTINGS, REPAIRS, Side finisher - windscreen.
2. Fit insulation pad to engine bulkhead. In this procedure, the front wing and the valance
3. Fit front mud flap. outer reinforcement (rear section) are replaced in
4. Fit road wheel and tighten nuts to 140 Nm (103 conjunction with the 'A' post assembly. The dash side lbf.ft). assembly can also be replaced in this procedure if
5. Fit wiring harness to valance assembly. required.
6. Models with A/C: Fit A/C pipes to valance assembly. Remove
7. Fit PAS/ACE reservoir.
8. Fit brake pipes to valance assembly.
9. LHD models: Fit brake servo. BRAKES, REPAIRS, Servo - brake.
10. Fit ABS modulator unit. BRAKES, REPAIRS, Modulator unit - ABS.
11. Fit front bulkhead assembly. PANEL REPAIRS, REPAIRS, Front bulkhead assembly.
12. Connect leads/multiplug to alternator.
13. Connect battery leads, negative lead last.
10. Release sunroof drain tube and position aside.
11. Remove RH or LH front seat.
12. RH side:
13. Remove fascia.
14. Driver's side:
15. Remove relevant wiring from 'A' post.
16. Remove tread plate from front door aperture.
17. Release front carpet and position aside.
18. Remove front door aperture seal.
19. Remove engine bulkhead insulation.
1. Disconnect both battery leads, negative lead first.
2. Disconnect leads/multiplug from alternator.

3. Remove bonnet.

4. Remove front wing. EXTERIOR FITTINGS, REPAIRS, Wing - front - up to 03MY.
5. Remove RH or LH front door. DOORS, REPAIRS, Door - front.
6. Remove RH or LH sill finisher.
7. Remove windscreen. SCREENS, REPAIRS, Windscreen.
8. Diesel models: Remove ECM. ENGINE MANAGEMENT SYSTEM - Td5, REPAIRS, Engine control module (ECM).
9. Remove RH or LH 'A' post inner finishers and disconnect speaker multiplug (if fitted).

SEATS, REPAIRS, Seat - front. Remove CD autochanger. IN CAR ENTERTAINMENT, REPAIRS, CD autochanger.

INTERIOR TRIM COMPONENTS, REPAIRS, Fascia. Remove steering column support bracket.