Freelander Service Procedures
ENGINE - K SERIES KV6
12-3-114 OVERHAUL
35. Position ancillary belt tensioner, fit bolts and
tighten to 25 Nm (18 lbf.ft).
36. Clean LH and RH front timing belt covers.
37. Position LH and RH front timing belt covers, fit
and tighten bolts to 4 Nm (3 lbf.ft).
38. Clean idler pulley, position pulley to engine
front mounting plate and tighten Torx bolt to 45
Nm (33 lbf.ft).
39. Position alternator to front mounting plate.
40. Fit bolt and nut and bolt securing alternator to
front mounting plate and tighten to 45 Nm (33
lbf.ft).
41. Connect alternator multiplug.
42. Connect battery lead to alternator, fit and
tighten nut to 8 Nm (6 lbf.ft), fit terminal cover.
43. Clean LH rear timing belt cover.
44. Position LH rear timing belt cover, fit and
tighten bolts to 4 Nm (3 lbf.ft).
45. Clean RH rear timing belt cover.
46. Position RH rear timing belt cover, fit bolts and
tighten to 4 Nm (3 lbf.ft).
47. Position heat shield, fit bolts and tighten M6 bolt
to 9 Nm (7 lbf.ft) and M8 bolt to 25 Nm (18 lbf.ft).
48. Fit inlet manifold chamber - if fitted.
- K SERIES KV6, REPAIRS, Seals - inlet
manifold chamber - up to 03MY.
49. Position ancillary drive belt to crankshaft and
alternator pulleys.
50. Position engine mounting front bracket to
engine front plate and tighten bolts to 45 Nm
(33 lbf.ft).