Freelander Service Procedures
AUTOMATIC GEARBOX - JATCO
ADJUSTMENTS
44-3
Selector cable - adjust
$% 44.30.04
Adjust
1. Remove underbelly panel.
2. Loosen trunnion nut securing inner cable to
selector lever.
3. Move gear change lever into 'P' position.
4. Move selector lever on gearbox fully clockwise
to engage 'P' position.
5. Pull inner cable as far forward as possible, then
release. This will remove any backlash from the
cable.
6. Tighten trunnion nut to 6 Nm (4 lbf.ft).
7. Fit underbelly panel.
8. Move selector lever through its working arc;
from 'P' to '2' and back to 'P', checking that all
gear positions are correctly selected.
9. Check that the engine will start in 'P' and 'N'
positions and is inhibited when drive positions
are selected.
M44 1640