Bushes - tie bar - rear

Refit

1. Fit tie bar bushes to lower arm.
2. Position front washer and fit tie bar to lower arm.
3. Hinge lower arm down and fit tie bar to subframe.
4. Apply Loctite and fit bolt securing lower arm to hub, do not tighten bolt at this stage.
5. Fit bolt securing tie bar to subframe, do not tighten at this stage.
6. Fit rear washer and nut securing tie bar to lower arm, do not tighten at this stage.
7. Fit road wheel(s) and tighten nuts to correct torque. See INFORMATION, Torque wrench settings.
8. Remove stand(s) and lower vehicle.
9. Tighten the following fixings with the suspension at nominal trim height: Lower arm to hub bolt 100 Nm, Tie bar to subframe bolt 45 Nm, Tie bar to lower arm nut 80 Nm.

BUSHES - TIE BAR - REAR

Service repair no - 68.35.15

1. Refer to tie bar - rear. See this section.