Freelander Service Procedures
ENGINE - K SERIES KV6
OVERHAUL 12-3-107
Refit
1. Using a suitable cleaning solvent, clean sump
and mating face on lower crankcase. DO NOT
use a metal scraper on sealing surfaces.
2. Apply a 2 mm (0.1 in) bead of sealant, Part No.
STC 4600 along centre of sump flange, then
spread to an even film using a roller.
CAUTION: To avoid contamination,
assembly should be completed immediately
after application of sealant.
3. Position sump, fit bolts and tighten
progressively in the sequence shown to 35 Nm
(26 lbf.ft).
4. If fitted:Position engine oil cooler to sump
mounting bracket, fit and tighten nuts to 25 Nm
(18 lbf.ft).
5. Position dipstick tube to sump and cylinder
block, fit bolt and tighten to 9 Nm (7 lbf.ft).
6. Fill engine with oil.
LUBRICANTS AND SEALANTS,
Lubrication.
Camshaft timing belt
$% 12.65.18.01
Remove
1. Remove 4 bolts securing engine mounting
bracket to engine front plate and remove
bracket.
2. Release and remove ancillary drive belt from
remaining pulleys.
3. Remove 2 bolts securing ancillary drive belt
tensioner and remove tensioner.
M12 6675
10
9
1
3
5
8
4
7
2
6
M86 5264