Freelander Service Procedures
ENGINE - K SERIES KV6
12-3-80 OVERHAUL
Crankshaft front oil seal
$% 12.21.14.01
Remove
1. Remove camshaft timing belt.
OVERHAUL, Camshaft timing belt.
2. Remove crankshaft drive gear.
3. Fit thrust button, LRT-12-200/3 to end of
crankshaft.
4. Screw LRT-12-200 into crankshaft front oil
seal.
5. Tighten centre bolt of LRT-12-200 to remove oil
seal.
6. Remove and discard oil seal from LRT-12-200.
7. Remove thrust button from crankshaft.
Refit
1. Clean oil seal recess in oil pump and running
surface on crankshaft, ensure bolt holes are
clean and dry.
2. Fit oil seal guide from seal kit, over end of
crankshaft.
3. Position new seal on crankshaft up against oil
pump housing. Drift seal into place using tool
LRT-12-202.
CAUTION: Oil seal must be fitted dry.
4. Remove LRT-12-202 and oil seal guide from
crankshaft.
5. Clean crankshaft gear and wipe end of
crankshaft.
6. Fit drive gear to crankshaft.
7. Fit camshaft timing belt.