Range Rover Classic
ELECTRICAL
31
REPAIR
FRONT SEAT - MOTORS
Service repair no - 86.75.06
Remove
Four electric motors, mounted beneath each front
seat, control fore and aft movement, cushion height
front and rear, and angle of recline. Adjustment is
possible with either front door open, or with ignition
switched ON.
1. Position seat to give access to motors.
2. Disconnect battery negative lead.
3. Remove seat base trim.
4. Remove two securing screws from each side of
required motor.
5. Remove motor from mounting.
6. Disconnect drive cables by unscrewing ferrule.
7. Disconnect wires from multi-plug, remove motor.
Refit
8. Reverse removal procedure.
9. Check seat adjustment for correct operation.
FRONT SEAT - SWITCHES
Service repair no - 86.75.03
Remove
1. Disconnect battery negative lead.
2. Pry two finger tip controls from switch housing.
3. Removing switch housing cover by lightly
depressing sides of cover to disengage clips,
remove diaphragm.
4. Remove two crosshead screws and washers.
Lift switch assembly to gain access to two
multi-plugs.
5. Disconnect multiplugs, remove switch assembly.
Refit
6. Reverse removal procedure.
NOTE: If switch housing removal is
required it is necessary to remove seat to
gain access to two securing screws.
See
CHASSIS AND BODY, Repair, Front Seat
Electrical