Workshop Manuals Factory service & repair Rover
Rover 200 Workshop Manual (1995-1999)06 · Engine - K16
06 · Engine

Flywheel - 1.8 models

Make
Rover
Model
200 Workshop Manual
Year
1995–1999
Section
Repairs › Flywheel - 1.8 models
Engine - K16Flywheel - 1.8 models

FLYWHEEL - 1.8 MODELS

Service repair no - 12.53.07

Remove

  1. Remove clutch assembly. See CLUTCH, Repairs.
  2. Leave tool 18G 1674 attached to cylinder block.
  3. Remove crankshaft position sensor. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
Flywheel - 1.8 models – Remove crankshaft position sensor. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
  1. Remove and discard 6 bolts securing flywheel to crankshaft.
  2. Remove flywheel from crankshaft.

Refit

  1. Using a tap, clean adhesive from threads of flywheel bolt holes in crankshaft.
  2. Clean flywheel and mating face of crankshaft.
  3. Fit flywheel to crankshaft.
  4. Fit NEW bolts securing flywheel to crankshaft and working in a diagonal sequence tighten bolts to 85 Nm.
  5. Fit crankshaft position sensor. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
  6. Fit clutch assembly. See CLUTCH, Repairs.

Parts & tools for this job For 1995 Rover 200

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.