Range Rover Classic
76
CHASSIS AND BODY
46
REPAIR
FRONT BUMPER
Service repair no - 76.22.08
Service repair no - 76.22.41 - End cap
Remove
End cap - each
1. Remove screw securing bottom of end cap.
2. From inside, remove 2 nuts and bolts securing
top of end cap.
3. Remove end cap.
Front bumper
4. Raise and support front of vehicle on safety
stands.
5. Remove radiator grille.
See Radiator Grille
6. Remove engine undertray.
7. Remove front spoiler assembly.
See Front
Spoiler
8. Release 2 clips and disconnect headlamp
washer pipes from ’T’ piece. Plug pipe ends.
9. Remove 4 bolts securing bumper to chassis
frame.
10. Remove bumper assembly.
Do not carry out
further dismantling if component is removed
for access only.
11. Release 2 clips and disconnect pipes from
headlamp washers.
12. Remove pipe and valve assembly.
13. Remove nut and washer and remove each
washer jet.
14. Tranfer components removed to new bumper.
Refit
15. Reverse removal procedure.