Inspection
- Make
- Rover
- Model
- 600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
- Section
- Repairs › Inspection
Automatic gearboxInspection · page 1 of 3
| A | Locknut | L | 3rd/4th clutch assembly |
| B | Conical spring washer | M | 3rd gear collar |
| C | Idler gear | N | Thrust needle bearing |
| D | Gearbox housing bearing | O | Needle bearing |
| E | Snap ring | P | 3rd gear |
| F | Collar | Q | Thrust needle bearing |
| G | Thrust needle bearing | R | Set ring – 32 mm |
| H | 4th/reverse gear | S | Needle bearing |
| I | Needle bearings | T | Sealing ring – 29 mm |
| J | Thrust needle bearing | U | Sealing rings – 35 mm |
| K | 4th gear collar | V | Mainshaft |
| W | 'O' rings |
Inspection
- Check mainshaft splines for wear and damage.
- Check bearings for wear and roughness, gear teeth for chipping.
Reassembly
- Wrap mainshaft splines with tape to prevent damage to 'O' rings.
- Install thrust needle bearings with unrolled edge of bearing retainer facing washer.
Parts & tools for this job For Rover 600
- PARTTransmission filter kitSearch: Rover 600 transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Rover automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.