Valve spring identification
- Make
- Rover
- Model
- 600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
- Section
- Repairs › Valve spring identification
Automatic gearboxValve spring identification
- Hold the regulator spring cap in place while removing the stopper bolt. Once the stopper bolt is removed, release the spring cap slowly.
CAUTION: The regulator spring cap can spring out when the lock bolt is removed.
- Clean all parts thoroughly in solvent or cleaner, and dry with compressed air. Blow out all passages.
- Replace valve body as an assembly if any parts are worn or damaged.
- Check all valves for free movement. If any fail to slide freely, see Valves and valve body.
- Reassembly is the reverse order of dismantling.
Note: Coat all parts with transmission fluid; fit a new filter.
- Align the hole in the regulator spring cap with the hole in the valve body; then press the spring cap into the valve body and tighten the stopper bolt to 12Nm.
Valve spring identification
| No. | Valve spring | Standard (New) | |||
|---|---|---|---|---|---|
| Wire diameter | Outside diameter | Free length – new | No. of coils | ||
| AA | Regulator spring A | 1.8 | 14.7 | 86.5 | 16.5 |
| BB | Regulator spring B | 1.8 | 9.6 | 44.0 | 12.7 |
| CC | Stator reaction spring | 4.5 | 35.4 | 30.3 | 1.9 |
| DD | Lock – up timing valve | 0.8 | 6.6 | 51.1 | 14.7 |
| EE | Torque converter check valve | 1.1 | 8.4 | 36.4 | 12.0 |
Parts & tools for this job For Rover 600
- PARTEngine gasket setSearch: Rover 600 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.