LR3/Disco 3
Jacking
General
l
Position vehicle on a solid, level surface.
l
Apply the parking brake.
l
Select 'P' - PARK on automatic transmission selector or 1st gear on manual transmission and 'H' High on transfer
case.
l
Body structure other than any approved jacking or lifting points
l
Bumpers
l
Fuel lines
l
Fuel tank
l
Brake lines
l
Front or rear suspension arms
l
Steering linkage
l
Transfer case
l
Front or rear differential units
l
Transmission
l
Engine oil pan - See note below
NOTE:
Vehicle jack
WARNING: The following instructions must be adhered to before raising the vehicle off the ground:
WARNING: If the drive shaft(s) are to be disconnected, it will be necessary to raise all four wheels off the
ground in order that the shaft(s) can be rotated. DO NOT use the customer jack and ensure that the vehicle is
adequately supported on axle stands. With the vehicle raised, it will be necessary to release the park brake and
select Neutral - 'N' in the main transmission to enable the drive shaft(s) to be rotated
CAUTION: To avoid damage to the underbody components of the vehicle, the following instructions
must be adhered to:
CAUTION: Do not position jacks or axle stands under the following components:
For certain repair operations, it may be necessary to support the engine under the oil pan. In this case, a block of
hardwood or a rubber pad must be positioned on the jack lifting pad to protect the oil pan.