LR3/Disco 3
Yaw Rate Sensor (70.70.35)
Removal
Installation
Published : Oct 13, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00 Charging System - General Information)
2 .
Remove the floor console. For additional information, refer to
Floor Console (76.25.01)
(Section 501-
12 Instrument Panel and Console)
3 .
CAUTION: Make sure the wiring harness is protected when cutting the carpet.
Remove the yaw rate sensor.
Cut the carpet for access.
Position the wiring harness aside.
Disconnect the electrical connector.
Remove the two retaining bolts.
1 .
Install the yaw rate sensor.
Tighten the bolts to 7 Nm (5 lb.ft).
Connect the electrical connector.
Attach the wiring harness.
Attach the carpet.
2 .
Install the floor console. For additional information, refer to
Floor Console (76.25.01)
(Section 501-12
Instrument Panel and Console)
3 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00
Charging System - General Information)
4 .
If a new yaw rate sensor has been installed, interrogate the ABS system using T4.