ABS Module Removal for LR3/Disco 3 - Anti-Lock Braking System Maintenance
Anti-Lock Brake System (ABS) Module (70.25.12)
Removal
Installation
Published : Oct 13, 2004
CAUTION: Make sure the ignition switch is in position 0.
1 .
Remove the cover.
2 .
Disconnect the electrical connector.
3 .
CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the
fluid and clean the area with water.
CAUTION: Before the disconnection or removal of any components, ensure the area around
joint faces and connections are clean. Plug any open connections to prevent contamination.
Disconnect the 6 brake tubes.
Position an absorbent cloth to collect fluid spillage.
4 .
Remove the ABS module from the mounting bracket.
Loosen, but do not remove, the 2 nuts securing the ABS module to the bracket.
1 .