LR3/Disco 3
Low Tire Pressure Module (86.54.05)
Removal
NOTE :
Published : Jul 14, 2004
If the tire pressure module is to be replaced then T4 must be connected and the correct procedures adhered to,
prior to battery disconnection.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the LH A-pillar upper trim panel. For additional information, refer to
A-Pillar Trim Panel
(76.13.26)
(Section 501-05)
3 .
Remove the LH B-pillar upper trim panel. For additional information, refer to
B-Pillar Upper Trim
Panel (76.13.28)
(Section 501-05)
4 .
Remove the LH C-pillar upper trim panel. For additional information, refer to
C-Pillar Upper Trim
Panel (76.13.35)
(Section 501-05)
5 .
Remove the LH sun visor.
Remove the cover.
Remove the 2 screws.
Disconnect the electrical connector.
6 .
Remove the sun visor retaining clip.
Release the screw cover.
Remove the screw.