LR3/Disco 3
Front Bumper Cover (76.22.72)
Removal
Published : May 4, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the fender mouldings. For additional information, refer to
Fender Moulding (76.43.54)
(Section 501-08)
3 .
Remove the 14 front bumper cover screws.
4 .
NOTE :
Some fluid spillage is inevitable during this operation.
Remove the front bumper cover.
Disconnect the 2 electrical connectors.
Release the head lamp washer jet hose from the washer pump.
Allow the fluid to drain into a container.
5 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the washer jets. For additional information, refer to
Headlamp Washer Jet (84.20.08)
(Section 501-16)
6 .
Remove the parking aid sensors.
Disconnect the electrical connector.
Release the 2 clips.
Repeat the above procedure for the remaining 3 sensors.