LR3/Disco 3
Clutch Master Cylinder (33.20.01)
Removal
Published : May 10, 2004
CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and
clean the area with water.
1 .
Remove the driver side closing trim panel.
Release the clip.
Remove the 2 screws.
Disconnect the electrical connector.
2 .
Release the clutch master cylinder clevis pin.
Remove the clip.
3 .
Remove clutch pedal spring assister.
4 .
CAUTION: Before disconnecting or removing the components, ensure the area around the joint
faces and connections are clean. Plug open connections to prevent contamination.
Release the clutch master cylinder.
Position a container to collect the fluid.
Disconnect the electrical connector.
Remove the 2 bolts.
Remove the clip.