LR3/Disco 3
Fuel Charging and Controls
Component Locations
GENERAL
The TdV6 is equipped with a High-Pressure (HP) common rail fuel injection system. With this fuel injection process, a
High-Pressure Pump (HPP) delivers a uniform level of pressure to the shared fuel lines (the common rails), which serve
all six fuel injectors. Pressure is controllable, to the optimum level for smooth operation, up to 1650 bar.
The common rail system supports a pre-injection (pilot) phase, which reduces combustion noise and mechanical load.
Fuel injection pressure is generated independently of engine speed and fuel injection events.
The fuel injection timing and volume are calculated by the Engine Control Module (ECM), which then energizes the
Published : Apr 30, 2004
Item Part Number
Description
1
-
High-pressure (HP) fuel rail (2 of)
2
-
HP pipe - Fuel rail to injector (6 of)
3
-
Injectors (6 of)
4
-
Low Pressure (LP) pipe - Fuel return
5
-
HP pipe - High Pressure Pump (HPP) to fuel diverter rail
6
-
LP pipe - Injector leak-back
7
-
Connector to injector (part of 6)
8
-
HPP
9
-
HPP pulley
10
-
HP diverter rail
11
-
Rear Engine Accessory Drive (READ) belt tensioner
12
-
LH exhaust camshaft pulley