LR3/Disco 3
Clutch Disc and Pressure Plate (33.10.01)
Special Service Tools
Pilot (spigot) bearing installer/clutch alignment
303-1096
Removal
Installation
Published : Jun 16, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the transmission. For additional information, refer to
Transmission (37.20.02.99)
(Section
308-03)
3 .
CAUTION: Working in a diagonal sequence, progressively loosen the bolts.
NOTE :
Restrain the flywheel.
Remove the pressure plate and clutch disc.
Remove the 6 bolts.
1 .
NOTE :
The clutch cover is self adjusting. It is recommended that a clutch disc and clutch cover is replaced
as an assembly. If a used clutch cover is assembled with a new clutch disc, the clutch cover
adjustment must be reset prior to assembly. With the clutch cover supported under its outside edge,