LR3/Disco 3
Roof Opening Panel Glass (76.84.03)
Removal
Installation
Published : May 4, 2004
1 .
Open the roof opening panel blind.
2 .
Open the roof opening panel to the tilt position.
3 .
Remove the roof opening panel glass.
Remove the 3 Torx screws.
Repeat the above procedure for the other side.
1 .
Install the roof opening panel glass.
Install the Torx bolts, but do not tighten fully at this stage.
2 .
Align the roof opening panel glass. For additional information, refer to
Roof Opening Panel
Alignment (76.84.82)
(Section 501-17)