Range Rover P38
76
CHASSIS AND BODY
NEW RANGE ROVER
38
REPAIR
REAR DOOR ASSEMBLY
Service repair no - 76.28.02/99
Remove
1. Release door harness protective sleeve from
’B/C’ post.
2. Disconnect door harness multiplugs.
3. Remove check strap retaining pin.
CAUTION: Apply protective tape to ’B/C’
post before drifting out pin.
4. Remove hinge pin retaining clips.
5. With assistance, remove door assembly.
Refit
6. With assistance fit door to hinges.
7. Fit hinge retaining clips.
8. Align check strap and fit retaining pin.
9. Remove protective tape.
10. Connect harness multiplugs, secure protective
sleeve to ’B/C’ post.
11. If necessary adjust door.
See Adjustment.
GLASS - REAR DOOR
Service repair no - 76.31.02
Remove
1. Remove outer waist seal.
See this section.
2. Remove door trim casing.
See this section.
3. Remove speaker and plastic sheet.
See this
section.
4. Remove window motor and control panel
assembly.
See ELECTRICAL, Repair.
5. Remove glass rear channel.
See this section.
6. Remove wedges or tape from glass.
7. Release glass from channel. Raise to remove
glass from door.
Refit
8. Fit glass to door and align to frame.
9. Wedge or use tape to hold glass in door.
10. Fit glass rear channel.
See this section.
11. Fit window motor and control panel.
See
ELECTRICAL, Repair.
12. Fit speaker and plastic sheet.
See this section.
13. Fit trim casing.
See this section.
14. Fit outer waist seal.
See this section.