Range Rover P38
CHASSIS AND BODY
47
REPAIR
Refit Glove Box Lid
8. Position lid to glove box and secure with bolts
and square nuts.
9. Engage gas strut, secure with split pin.
Refit Glove Box Assembly
10. Position glove box assembly, connect lamp
multiplug. Secure cable latch.
11. Open glove box lid, align assembly to fascia.
Secure with screws.
12. Fit bolts securing hinges to fascia frame, do no
tighten.
13. Check alignment and latching of glove box lid,
adjusting hinges as necessary using central
adjusting screws.
14. Tighten screws, hinges to fascia.
15. Close glove box lid.
16. Position closing panel. Secure with scrivet
fasteners.
GLOVE BOX RELEASE CABLE
Service repair no - 76.52.14
NOTE: Release cables are supplied preset
and do not normally require adjustment.
Remove
1. Open glove box. Remove 5 screws securing
glove box liner to fascia.
2. Lower glove box liner. Release 2 clips to
disengage cable latch from location.
3. Remove finisher from lock.