Range Rover P38
CHASSIS AND BODY
81
REPAIR
WINDSCREEN
Service repair no - 76.81.01
NOTE: The following equipment is
required:
masking tape;
sharp knife;
reciprocating blade, powered cutting knife*, or
cutting wire and handles;
suction lifters;
windscreen repair kit;
sealer applicator gun.
* A reciprocating blade cutting tool, such as ’FEIN
Special Cutter’, is recommended for this operation. A
flat blade, with an effective length of at least 25mm
and a ’U’ shaped blade of at least 30mm is required.
CAUTION: Extreme care is necessary to
ensure that paintwork and trim does not
become damaged during the removal
process.
Particular care should be taken when using
cutting wire and handles to avoid damage to seal
along leading edge of fascia.
WARNING: Wear protective gloves when
handling glass, solvents and primers.
Remove
1. Remove interior mirror.
See this section.
2. Remove plenum panels.
See HEATING AND
VENTILATION, Repair.
3. Insert a thin plastic strip, such as a credit card,
between windscreen upper finisher and roof
panel.
4. Disengage 8 clips securing upper finisher by
sliding clips towards left hand side of vehicle.
5. Remove upper screen finisher.