Range Rover P38
76
CHASSIS AND BODY
NEW RANGE ROVER
28
REPAIR
FRONT DOOR ASSEMBLY
Service repair no - 76.28.01/99
Remove
1. Release door harness protective sleeve from ’A’
post.
2. Disconnect door harness multiplugs.
3. Remove door check strap retaining pin.
CAUTION: Apply protective tape to ’A’
post before drifting out retaining pin.
4. Remove door hinge pin retaining clips.
5. With assistance, remove door assembly.
Refit
6. With assistance, position door on hinges. Fit
retaining clips.
7. Align door check strap. Fit retaining pin.
8. Remove protective tape from ’A’ post.
9. Connect harness multiplugs. Secure protective
sleeve to ’A’ post.
10. If necessary adjust door.
See Adjustment.
GLASS - FRONT DOOR
Service repair no - 76.31.01
Remove
1. Remove front door outer waist seal.
See this
section.
2. Remove front door plastic sheet.
See this
section.
3. Turn ignition ON.
4. Lower glass approximately 120mm (5 in.)
Remove rear regulator arm retaining clip.
5. Lower glass to align forward clip with the
regulator plate lower retaining rivet. Turn ignition
OFF.