LR3/Disco 3
Liquid contact dries the skin and can cause irritation or dermatitis. Splashes in the eye may be slightly irritating.
In normal circumstances the low volatility does not give rise to harmful vapors. Exposure to mists and vapors from
kerosene at elevated temperature should be avoided (mists may arise in dewaxing). Avoid skin and eye contact and
make sure there is adequate ventilation.
If swallowed, DO NOT induce vomiting - SEEK IMMEDIATE MEDICAL ATTENTION.
Gas Cylinders
Gases such as oxygen, acetylene, argon and propane are normally stored in cylinders at pressures of up to 138 bar
(13800 kPa) (2000 lbf/in²) and great care should be taken in handling these cylinders to avoid mechanical damage to
them or to the valve gear attached. The contents of each cylinder should be clearly identified by appropriate markings.
Cylinders should be stored in well ventilated enclosures, and protected from ice and snow or direct sunlight. Fuel gases,
for example acetylene and propane should not be stored in close proximity to oxygen cylinders.
Care should be exercised to prevent leaks from gas cylinders and lines and also to avoid sources of ignition.
Only trained personnel should undertake work involving gas cylinders.
General Workshop Tools and Equipment
It is essential that all tools and equipment are maintained in good condition and the correct safety equipment is used
where required.
Never use tools or equipment for any purpose other than that for which they were designed. Never overload equipment
such as hoists, jacks, axle and chassis stands or lifting slings. Damage caused by overloading is not always immediately
apparent and may result in a fatal failure the next time that the equipment is used.
Do not use damaged or defective tools or equipment, particularly high speed equipment such as grinding wheels. A
damaged grinding wheel can disintegrate without warning and cause serious injury.
Wear suitable eye protection when using grinding, chiselling or sand blasting equipment.
Wear a suitable breathing mask when using abrasive blasting equipment or using spraying equipment.
Make sure there is adequate ventilation to control dusts, mists and fumes.
High Pressure Air, Lubrication and Oil Test Equipment
Always keep high pressure equipment in good condition, and regularly maintained, particularly at joints and unions.
Never direct a high pressure nozzle, for example diesel injector, at the skin as the fluid may penetrate to the underlying
tissue and cause serious injury.
Jacking
Always refer to the Jacking and Lifting section of this manual prior to raising the vehicle off the ground.
When vehicle is to be raised by means of a jack, ensure that it is standing on level ground, that parking brake is applied
and wheels are chocked. ALWAYS use the recommended jacking points and ensure that vehicle jack has sufficient load
capacity for the weight of the vehicle.
Ensure that hoists have sufficient load capacity for the weight of the vehicle.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on
safety stands.
