Freelander Service Procedures
RESTRAINT SYSTEMS
75-16
REPAIRS
8. Disconnect SRS connector from airbag
module.
9. Remove airbag module.
WARNING: Store the airbag module with the
deployment side uppermost. If it is stored
deployment side down, accidental
deployment will propel the airbag module
with enough force to cause serious injury.
Refit
1. Position airbag module and connect SRS
connector to airbag module.
NOTE: If the airbag module is to be replaced,
the bar code of the new module must be
recorded.
2. Fit airbag to fascia and tighten Torx screws to
10 Nm (7 lbf.ft).
3. Align lower finisher to bracket.
4. Fit 4 screws securing lower finisher bracket.
5. Fit and secure lower finisher clips
6. Fit 2 screws securing airbag module to fascia.
7. Connect battery leads, earth lead last.
Diagnostic control unit (DCU)
$% 76.74.06
Remove
WARNING: It is imperative that before any
work is undertaken on the SRS system the
appropriate information is read thoroughly.
1. Make the SRS system safe.
Supplementary restraint system
precautions.
2. Remove heater assembly.
3. Disconnect multiplug from DCU.
4. Remove 3 Torx bolts securing DCU to body and
remove DCU. Discard Torx bolts.
Refit
1. Fit DCU to body and secure with new bolts.
Tighten bolts to 9 Nm (7 lbf.ft).
2. Connect multiplug to DCU.
3. Fit heater assembly.
4. Connect battery leads, earth lead last.