Assembly (Cont'd) - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › Assembly (Cont'd) - Nissan 180SX S13 Workshop Manual
Assembly (Cont'd)
ASSEMBLY
Assembly (Cont'd)
3. Install front side clutch and gear components.
a. Install rear sun gear on transmission case. @ Pay attention to its direction.
SAT974A
b. Make sure needle bearing is on front of front planetary carrier. e@ Apply petroleum jelly to needle bearing.
c. Make sure needle bearing is on rear of front planetary carrier. @ Apply petroleum jelly to bearing. @ Pay attention to its direction — Black side goes to front.
to front. SATSETA
d. While rotating forward clutch drum clockwise, install front planetary carrier on forward clutch drum.
é 7) SATS969A
@ Check that portion A of front planetary carrier protrudes approximately 2 mm (0.08 in) beyond portion B of forward Front planetary carrier jo
clutch assembly.
Portion A—s= Forward clutch drum Portion B—— SATS70A
e. Make sure bearing races are on front and rear of clutch pack. @ Apply petroleum jelly to bearing races. @ Securely engage pawis of bearing races with holes in clutch pack.
Front Rear SATOTIA
AT-148
Parts & tools for this job For Nissan 180SX
- PARTTransmission filter kitSearch: Nissan 180SX transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Nissan automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
As an Amazon Associate we earn from qualifying purchases.