Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

REMOVAL AND INSTALLATION - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › REMOVAL AND INSTALLATION - Nissan 180SX S13 Workshop Manual
AT automatic transmissionREMOVAL AND INSTALLATION - Nissan 180SX S13 Workshop Manual

REMOVAL AND INSTALLATION

REMOVAL AND INSTALLATION

Removal @ Remove fluid charging pipe from A/T assembly. @ Remove bolts securing torque converter to drive plate. @ Remove those bolts by turning crankshaft. @ Plug up opening such as oil charging pipe hole, etc.

Installation @ Drive plate runout Maximum allowable runout:

0.5 mm (0.020 in) If this runout is out of allowance, replace drive plate with ring gear.

@ When connecting torque converter to transmission, measure distance “A” to be certain that they are correctly assembled. Distance “A”:

23.5 mm (0.925 in) or more install converter to drive plate. \Straightedge Reinstall any part removed. ai Distance“A : After converter is installed to drive plate, rotate crankshaft Mel mak 9 several turns and check to be sure that transmission et rotates freely without binding. “~ ie be —" SATOI7BE @ Tighten bolts securing transmission.

Bolt No.. . . _| Tightening torque N-«m (kg-m, ft-lb)Bolt lenght ’L” mm (in)
139 - 49 (4.0 - 5,0, 29 - 36)80 (3.15)
239 - 49 (4.0 - 5.0, 29 - 36)75 (2.95)
339 - 49 (4.0 - 5.0, 29 - 36)55 (2.17)
429 - 39 (3.0 - 4.0, 22 - 29}40 (1.57)
529 - 39 (3.0 - 4.0, 22 - 29)25 (0.98)
Gusset to engine29 - 39 (3.0 - 4.0, 22 - 29)20 (0.79)

‘ © A/T to Engine

@ Engine (gusset) (5) to AIT SATS10B

@ Reinstall any part removed. Check fluid level in transmission. Move selector lever through all positions to be sure that transmission operates correctly. With parking brake applied, rotate engine at idling. Move selector lever through “N” to “D’, to “2”, to "1" and to “R”. A slight shock should be felt by hand gripping selector each time transmission is shifted. @ Perform road test. — Refer to “ROAD TESTING”. SAT63BA AT-75

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.