Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

ON-VEHICLE SERVICE - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › ON-VEHICLE SERVICE - Nissan 180SX S13 Workshop Manual
AT automatic transmissionON-VEHICLE SERVICE - Nissan 180SX S13 Workshop Manual

ON-VEHICLE SERVICE

ON-VEHICLE SERVICE

Parking Components Inspection (Cont'd)

3. Remove rear extension from transmission case. Replace parking components if necessary.

4. Reinstall any part removed.

5. @ Always use new sealing parts.

Inhibitor Switch Adjustment

1. Remove manual contro! linkage from manual shaft of A/T assembly.

2. Set manual shaft of A/T assembly in “N° position.

3. Loosen inhibitor switch fixing bolts.

4 Insert pin into adjustment holes in both inhibitor switch and manual shaft of A/T assembly as near vertical as possible.

5. Reinstall any part removed.

6. Check continuity of inhibitor switch. — Refer to ‘Electrical Components Inspection’.

Manual Control Linkage Adjustment

Move selector lever from “P”’ range to “1” range. You should be able to feel the detents in each range. if the detents cannot be felt or the pointer indicating the range is improperly aligned, the linkage needs adjustment. Place selector lever in “P”’ range.

1.

2. Loosen lock nuts.

_-SATBOZ6

3. Tighten lock nut @ until it touches trunnion pulling selector

“pt range

lever toward “R" range side without pushing button,

@ to the specified torque. Lock nut: 11 - 15 Nem (1.1 - 1.5 kg-m, 8 - 11 ft-lb) ():

4. Back off lock nut @ 1 turn and tighten lock nut

Move selector lever from “P” range to “1” range. Make sure

5.

that selector lever can move smoothly.

Lock nut) 7 Lock nut 9) SAT78B8

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.