Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual
AT automatic transmissionTROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 13

i Al RX O/D

SYMPTOM: A/T does not hold lock-up condition for

more than 30 seconds.

Self-diagnosis start

Does self-diagnosis show damage |

4 i -- Light ,|

Check engine revolution signal

to engine revolution signal circuit circuit. after cruise test? — Refer to ‘Self- diagnosis”. No 1 SAT763B

1. Remove oil pan.

NG}

4 Remove control valve assem-

2. Check A/T fluid condition. bly. -- Refer to “ON-VEHI- OK.

CLE SERVICE”,

2. Check the following items. @ Lock-up control valve | ® Pilot vaive OK. ° Pitot filter

3. Disassemble A/T. OK. 4, Check torque converter and TM L oil pump assembly. SATI71B ’: N.G. Check again. »

1. Perform A/T control unit input/output signal inspection. OK.

2. tf N.G., recheck A/T control

d unit pin terminals for damage

INSPECTION END

or connection of A/T control

unit harness connector, eT, BED

Diagnostic Procedure 14

1] OQ 2% OFF

SYMPTOM: Lock-up is not released when accelerator

pedal is released. Self-diagnosis start ll

Does self-diagnosis show damage

Yes _| Check idle switch circuit. — Refer

p—— +e — ee Light to idle switch circuit after cruise to “Self-diagnosis’”’. test? ——j—-—— Shade No 2 | + SATIS7C

Check again.

NG. 1, Perform A/T control unit

(2) Accelerator pedal input/output signal inspection. ia

2. 1fN.G., recheck A/T control

unit pin terminals for damage

INSPECTION END

or connection of A/T control

unit harness connector.

Pa 0/8 SATBOGA

AT-58

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.