Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual
AT automatic transmissionTROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

LOCK-UP SOLENOID CIRCUIT CHECK

Lock-up solenoid | | |N.G.

CHECK GROUND cirRcuIT.

CTE Lo

1. Remove ail pan. — Refer to 1 -

“ON-VEHICLE SERVICE”.

_— Terminal cord assembly —L . Check the following items. bh ® Lock-up solenoid — Refer to “Electrical Components

2. Disconnect terminal cord 22 Inspection”. assembly connector in engine AIT control unit ® Harness continuity of terminal compartment. cord assembly —_

3. Check resistance between SAT7694

terminal @ and ground.

a Resistance: 2.5 - 592 harness Fi TS. Bl OK. connector L DISCONNECT ¥v €))

CHECK POWER SOURCE

N.G. Repair or replace harness between A/T control unit and CIRCUIT. terminal cord assembly. (Main harness)

?. Disconnect A/T control unit SAT746B 16-pin connector. 7

3. Check resistance between

terminal @ and A/T contro!

unit terminal QD. DISCOMNECT A €) Resistance: Approximately 042 tee © Py am

4. Reinstall any part removed. harness ne

22) connector

\ OLE. hem GY/R ¥

Perform self-diagnosis after

N.G. | 4. Perform A/T control unit

eg

driving for a while.

-

input/output signal inspection.

2. 1fN_G., recheck A/T control

OK. eee unit pin terminals for damage DISCONNECT (4)A €) 5 ¥ or connection of A/T control

INSPECTION END

unit harness connector. = 2 | 7 GYIR AIT control unit terminal

SAT74A7TB

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.