Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

ON-VEHICLE SERVICE - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › ON-VEHICLE SERVICE - Nissan 180SX S13 Workshop Manual
AT automatic transmissionON-VEHICLE SERVICE - Nissan 180SX S13 Workshop Manual

ON-VEHICLE SERVICE

ON-VEHICLE SERVICE

Control Valve Assembly and Accumulators

Inspection

1. Remove oil pan and gasket and drain A.T-F.

2. Remove oil strainer.

3. Remove control valve assembly by removing fixing bolts and disconnecting harness connector. Bolt fength and location

Bolt symbol2mm (in) Ema Q
@33 (1.30)
45 (1.77)

4. Remove solenoids and valves from valve body if necessary.

5. Remove terminal cord assembly if necessary.

6. Remove accumulator A, B, C and D by applying compressed 7 air if necessary. @ Hold each piston with rag.

7. Reinstall any part removed. @ Always use new sealing parts.

SATO74B

AT-7

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.